This offer ends in:
- Stock: 8
- Brand: Peacefair
- Reward Points: 105
- Model: PZEM-026
- Weight: 0.09kg
- Product Code: 7013-022
Digital Panel Meter with Large LCD Display for Home, Office and Industrial Installations
The Peacefair PZEM-026 is a digital AC electrical meter for single-phase systems designed to measure and display voltage and current simultaneously. Featuring a non-contact CT (current transformer) for safe current sensing up to 100 A and a clear LCD display, it’s ideal for power monitoring in homes, workshops, panels and other AC installations.
Key Features:
Voltage range: AC 40–400 V — suitable for standard single-phase mains.
Current range: AC 0–100 A — measured via included non-contact CT sensor.
Simultaneous display: voltage and current shown together on an LCD screen.
Compact panel mount: designed for easy installation in control boxes or panels.
Typical Uses:
✔ Monitoring AC electrical loads and mains performance (appliances, motors, generators).
✔ Tracking current and voltage levels for safety and diagnostics.
✔ Integrating into electrical control panels and power distribution setups.
Note: As an AC mains measurement device with a current transformer, it should be installed and used in compliance with electrical safety standards.
Attention
2. This product is suitable for AC, not DC test.
3. This product is suitable for single phase power frequency AC power grid, not used with other waveform.
4. The measurement voltage and ampere shall not exceed the calibration range.
5. Make sure the wiring is correct.
Backlight control
Measurement range: 40～400V
Accuracy: ±1%
2. Ampere
Measurement range: 0～100A
Starting measurement:0.02A
Accuracy: ±1%
Step 1: long press the key (about 3 seconds) until the screen digit flashes, then release the key;
Step 2: Digital flicker means entering error adjustment state, and the digit cycle flickers in sequence: voltage high digit→voltage middle digit→voltage low digit→voltage decimal point→ampere high digit→ampere middle digit→ampere low digit→ampere decimal
point. The flicker represents the present adjustable digit, short press the key to adjust the value (Digital 0-9 cycle, decimal point shift);
Step 3: long press the key (about 3 seconds) after the adjustment, the screen display PASS and return to the normal display interface, means the adjustment is successful.
